![]() ![]() Take a moment after every few tiles to ensure that all of your lines meet up and the entire floor looks sharp and consistent.Īs you work, be careful not to step on any installed tiles. Then, move back to the center point of the reference lines, and continue to place tiles adjacent to the first row. Once you reach the wall with the first row, take note of the gap at the end that may require a custom-cut piece. You can also do this across multiple rows when you have more tiles installed. If the marble is polished you may want to cover the front of the wood with a piece of carpet to prevent scratches. Place the board across the tiles, and tap the board lightly with the rubber mallet. ![]() If the last row of tiles against any of the walls is less than a few inches wide, adjust your chalk line grid as needed so that the tiles along the walls are an acceptable width, based on your preference.Īfter placing every three or four tiles, use a 2x4 board to ensure that they are at a uniform height. Snap a chalk line across the floor using the pencil line as a guide, dividing the floor into four equal quadrants.Ĭheck your layout by test-fitting full tiles along both reference lines from wall to wall. Then, measure to the center of that line, and use a T-square to draw a perpendicular line at the mark, using a pencil. In order to achieve this symmetrical effect, you need to create reference lines on the surface of the cement board underlayment.įind the center of two opposing walls and use a chalk line to mark a path between them, dividing the room in half. Your installation will look best if the tiles radiate outward from the center of the room, rather than starting abruptly from one of the walls. This may require some structural work to reinforce the joists supporting the subfloor before installing tiles. The Spruce Home Improvement Review Boardīecause marble is heavy, your subfloor should be extremely sturdy. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |